Skip to main content

TMC 2209

Loading...

Basic Parameters​

  • Input Voltage: 12V-24V
  • Compatible with: Marlin/Klipper/RRF firmware
  • Motor not prone to losing steps
  • Supports silent mode
  • Large area fan thermal pad to reduce drive operating temperature
  • Drive mode support: TMC:UART
  • Supports motor stall detection

Motherboard Jumper Instructions​

  • TMC2209 uses UART jumper

    Loading...

  • The UART pin of the FLY drive is the fourth pin counting down from the left; the PDN pin is the UART pin. If the motherboard pins do not correspond, UART cannot be used

  • For other drives that use the fifth pin, you can refer to this method for resolution if using our motherboard Solution for UART not working

    Loading...

TMC2209 Reference Configuration​

Danger

The drive sense resistor is 0.110, please do not set it incorrectly

[tmc2209 stepper_x]
uart_pin: 
interpolate: False
run_current: 0.8                    # Running current
sense_resistor: 0.110               # Drive sense resistor, do not change
stealthchop_threshold: 0

Limitless Use Instructions​

Infinite Position Usage Tips
  • Using infinite position requires occupying one limit port. Under normal circumstances, the first drive position uses IO1, the second drive position uses IO2, and so on.
  • When using infinite position, please note: do not connect anything to the corresponding limit port.
  • Some FLY motherboards are directly connected to the drive port. Please check whether DIAG is directly connected to the corresponding pin.
Tips for limitless use
  • The original endstop_pin: needs to be commented out or deleted, then add endstop_pin: tmc2209_stepper_x:virtual_endstop
  • After configuring diag_pin:, the limit status will show as not triggered
  • The driver_SGTHRS: value needs to be tested and adjusted to an appropriate value
Loading...
  • Reference configuration
Tip
  • FLY 2209 has a DIP switch on the back that needs to be flipped to the other side
  • FLY 2209C uses a direct drive DIAG, so this step is not required
[stepper_x]
# endstop_pin:
endstop_pin: tmc2209_stepper_x:virtual_endstop
homing_retract_dist: 0        # If retract is not set to 0, homing may fail

[tmc2209 stepper_x]
diag_pin: ^
driver_SGTHRS: 100

Loading...