Wiring

tip

• ALPS offers various wiring methods
• Please choose based on your actual situation

tip

• Firmware configuration is required after wiring
• The module pressure threshold can be adjusted only after the firmware configuration is completed

Using the Motherboard UART Port (PA9, PA10)

• A two-meter adapter cable is included in the ALPS package
• This cable can be connected to the motherboard UART port (PA9, PA10)
  

Using the BL-Touch Port

• When using the BL-Touch port, you need to crimp terminals yourself (specification XH2.54)
• Please note that if you need to use the BL-Touch port, the yellow wire must be connected to the middle servo signal interface
  

Using the Endstop Port

• When using the endstop port, you need to crimp terminals yourself (specification XH2.54)
• Please note that if using a high-voltage endstop port such as gpio20 on SHT36 V3, a jumper is required; otherwise, it will not function properly