12864

Klipper配置

情報

• 正确连接到EXP接口后，将示例配置中的mini12864部分取消注释即可

Marlin 配置方法

• 在配置中添加即可

  #if HAS_WIRED_LCD
  
  #define BEEPER_PIN                 EXP1_10_PIN
  #define BTN_ENC                    EXP1_09_PIN
  
  #if ENABLED(CR10_STOCKDISPLAY)
  
      #define LCD_PINS_RS              EXP1_07_PIN
  
      #define BTN_EN1                  EXP2_08_PIN
      #define BTN_EN2                  EXP2_06_PIN
  
      #define LCD_PINS_ENABLE          EXP1_08_PIN
      #define LCD_PINS_D4              EXP1_06_PIN
  
  #elif ENABLED(MKS_MINI_12864)
  
      #define DOGLCD_A0                EXP1_04_PIN
      #define DOGLCD_CS                EXP1_05_PIN
      #define BTN_EN1                  EXP2_08_PIN
      #define BTN_EN2                  EXP2_06_PIN
  
  #else
  
      #define LCD_PINS_RS              EXP1_07_PIN
  
      #define BTN_EN1                  EXP2_06_PIN
      #define BTN_EN2                  EXP2_08_PIN
  
      #define LCD_PINS_ENABLE          EXP1_08_PIN
      #define LCD_PINS_D4              EXP1_06_PIN
  
      #if ENABLED(FYSETC_MINI_12864)
      #define DOGLCD_CS              EXP1_08_PIN
      #define DOGLCD_A0              EXP1_07_PIN
      //#define LCD_BACKLIGHT_PIN           -1
      #define LCD_RESET_PIN          EXP1_06_PIN  // Must be high or open for LCD to operate normally.
      #if EITHER(FYSETC_MINI_12864_1_2, FYSETC_MINI_12864_2_0)
          #ifndef RGB_LED_R_PIN
          #define RGB_LED_R_PIN      EXP1_05_PIN
          #endif
          #ifndef RGB_LED_G_PIN
          #define RGB_LED_G_PIN      EXP1_04_PIN
          #endif
          #ifndef RGB_LED_B_PIN
          #define RGB_LED_B_PIN      EXP1_03_PIN
          #endif
      #elif ENABLED(FYSETC_MINI_12864_2_1)
          #define NEOPIXEL_PIN         EXP1_05_PIN
      #endif
      #endif // !FYSETC_MINI_12864
  
      #if IS_ULTIPANEL
      #define LCD_PINS_D5            EXP1_05_PIN
      #define LCD_PINS_D6            EXP1_04_PIN
      #define LCD_PINS_D7            EXP1_03_PIN
  
      #if ENABLED(REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER)
          #define BTN_ENC_EN           LCD_PINS_D7  // Detect the presence of the encoder
      #endif
  
      #endif
  
  #endif
  
  #endif // HAS_WIRED_LCD