📄️ Introduction
We are excited to release the brand-new FLY-Pi V2 host board. This board has the same mounting dimensions as the Raspberry Pi and can replace the Raspberry Pi as a host board running, featuring 1GB of onboard DDR3 memory, allowing it to run a full LINUX desktop (based on Armbian customized optimization). The board can be used with Klipper and RRF firmware, and even run the Klipper screen when using the SHT tool board.
📄️ System Flashing
Host Operation Guide for Beginners
📄️ SSH Connection to Host Machine
* You can connect to the device using serial port or WIFI
📄️ Connect to Wi-Fi
Install the Antenna on PI V2
📄️ 上位机供电
There are two power supply methods for FLY-Pi-V2.
📄️ Accelerometer Usage
Mainboard Wiring
📄️ Screen Wiring and Configuration
* FLY-TOOLS needs to be connected to the internet and access via the upper machine's IP+:9999
📄️ Onboard 5V Fan Port
The Pi-V2 board has an onboard 5V controllable interface for main controller cooling, and the wiring method is as shown in the figure below.
📄️ Onboard UTOC Usage
Turn on DIP Switch
📄️ Onboard 40PIN Header Diagram
📄️ I2C Usage
* Use the I2C interface on the 40-pin header of the host computer
📄️ 3D Models and Schematics
* This website does not yet support online previews; you can only preview them after downloading.