📄️ Introduction
We are pleased to release the new FLY-Pi V2 mainboard. This board has the same installation dimensions as the Raspberry Pi and can replace the Raspberry Pi as a mainboard, featuring 1GB of onboard DDR3 memory, allowing it to run a full LINUX desktop (based on Armbian custom optimization). The board can be used with Klipper and RRF firmware, and even runs the Klipper screen when using the SHT tool board.
🗃️ System image burning
4 items
📄️ SSH connection to host computer
* This document is only applicable to FLY host computer
📄️ Connect to WiFi
- There are slight differences in the steps and methods for connecting to WiFi between the FLYOS-FAST system and the FLYOS-Armbian system. Please select the tutorial corresponding to the system you have burned!
📄️ Host Computer Power Supply
There are two power supply methods for FLY-Pi-V2.
📄️ Accelerometer usage
Mainboard wiring
📄️ Screen Wiring and Configuration
Screen Wiring
📄️ Other Settings for Host Computer
## FLYOS-FAST System - Other Configurations
📄️ Onboard 5V Fan Port
Onboard 5V Fan Wiring
📄️ Power Loss Resume Function in Klipper
Overview
📄️ I2C Usage
* Use the I2C interface on pin 40 of the host computer
📄️ Onboard UTOC Usage
Turn on the DIP switch
📄️ Onboard 40PIN Header Diagram
📄️ 3D Model and Schematic
* This document provides the following