📄️ Introduction
Fly-MINI-Pad is an entry-level host for Klipper.
🗃️ System image burning
4 items
📄️ SSH connection to host computer
* This document is only applicable to FLY host computer
📄️ Connect to WIFI
Install the antenna on the MINI PAD
📄️ Screen Configuration
* FLY-TOOLS needs to be connected to the network on the host machine and then access it by entering IP+:9999 in the host machine.
📄️ Accelerometer usage
* The Mini Pad can directly connect an accelerometer via the on-board interface or use a tool version that has an built-in accelerometer
📄️ Power Supply for Host Computer
There are three power supply methods for FLY-MINI Pad.
📄️ Onboard UTOC Usage
It is not recommended to use two UTOICs; flashing and connecting will be very troublesome.
📄️ Connecting the Mainboard via UART
Please note that after using this method, you will not be able to use the accelerometer interface on mini pad to connect an external accelerometer.
📄️ 3D Model and Schematic
* This document provides the following