📄️ Introduction
BD sensor is a distance sensor that can be used in conjunction with 3D printers to perform real-time rapid bed leveling and adjust the z-axis.
📄️ Installation Guide
BDsensor can directly use the motherboard and tool board's BL-TOUCH* interface
📄️ klipper use
Connect the sensor cable to the motherboard or CAN bus tool headboard.
📄️ Marlin Usage
Connect the sensor cable to the motherboard or CAN bus tool headboard.
📄️ klipper automatic Z-OFFSET
This feature requires the BD sensor firmware version (which you can obtain by sending M102 S-1, not the hardware version on the sensor) to be V1.1b, greater than V1.2b, or the version purchased after March 2024. Otherwise, you need to use an external hardware tool (such as STlink) to flash the firmware into the BD sensor.
📄️ Marlin Automatic Z-OFFSET
This feature requires the BD sensor firmware version (which you can obtain by sending M102 S-1, not the hardware version on the sensor) to be V1.1b, greater than V1.2b, or purchased after March 2024. Otherwise, you need to use an external hardware tool (such as STlink) to flash the firmware into the BD sensor.