FLY-USB-LCD7 Introduction
FLY-USB-LCD7 is a 7-inch USB touchscreen based on the Artinchip D133 (RISC-V) chip. Once connected to a computer via a USB cable, it can be used as a USB display and audio device.
Type-C Cable Requirements
Please use a reliable USB Type-C data cable (supporting data transfer). Low-quality or charge-only cables may cause screen flickering, device recognition failure, or insufficient power supply.
Key Features
- 7-inch IPS screen, resolution 1024×600
- Capacitive touch (GT911), supports touch feedback buzzer
- USB video input (host pushes frames via MJPEG protocol)
- USB audio output
- Dual USB disk mode (FLY BOOT / FLY DATA), convenient for firmware upgrades and custom resources
- Long-press the bottom-left and bottom-right corners of the screen simultaneously to open the settings interface, where you can adjust backlight, volume, rotation, screensaver, etc.
- Automatically turns off the backlight after 30 seconds of no video signal; touch to wake
Screen Specifications
| Item | Specification |
|---|---|
| LCD Size | 7.0 inch |
| Resolution | 1024(RGB)×600 |
| Pixel Pitch | 0.0502(H) × RGB × 0.1432(V) mm |
| Active Display Area | 154.21(H) × 85.92(V) mm |
| Module Size | 164.9(H) × 100.00(V) × 3.5(T) mm |
| Surface Treatment | AG |
Product Overview
- Communication: USB
- Onboard Interfaces: TYPE-C, USB-A ×1, MX1.25-4P ×2, MX1.25-2P (speaker) ×1
- Operating Temperature: 0°-60°C
- Touch Type: Capacitive
Expansion Interfaces
- USB-A ×1: Standard USB-A interface, supports expansion of USB devices
- MX1.25-4P ×2: Universal pinout, supports expansion of USB devices
- MX1.25-2P ×1: Speaker interface, supports 4Ω 2.6W / 8Ω 1.6W small speakers (speaker not included)
Speaker Interface Power
The MX1.25-2P speaker interface has limited output power and only supports small speakers rated at 4Ω 2.6W or 8Ω 1.6W. Do not connect high-power speakers.
Package Contents
- FLY-USB-LCD7 screen ×1
- USB-C data cable ×1
Notes
- Please use a reliable USB-C data cable; low-quality cables may cause screen flickering or recognition failure
- The screen is powered via USB; please ensure the host USB port outputs ≥ 5V 1A
Loading...