Skip to main content

warning

FLY-Pi V3 Usage Notes

Read before operating

Be sure to disconnect the power before performing any wiring work! When flashing firmware, please also follow the guide's instructions.

1. Power Requirements​

  • Power via Type-C (recommended for first startup): Use a 5V/2A or above power adapter. Some computer USB ports may not provide sufficient power, which can cause the system's first automatic expansion to fail.
  • Powered via DC power terminal: Supports DC 12V-24V input, suitable for daily work scenarios.
  • For detailed power supply instructions, please refer to Host Power Supply.

2. Storage Configuration​

Important

FLY-Pi V3 Not included in factory shipment: no storage devices are included. You must configure at least one of the following storage media:

  • Option 1 (Recommended): Purchase the FLY custom M2WE Module.
  • Option 2: Provide your own Micro SD (TF) card, with a capacity between 16GB to 128GB.

3. Important Warnings​

Interface Conflict Warning

It is forbidden to use the TFT screen and SPI accelerometer interface at the same time!

The TFT screen interface (FPC-TFT) shares the same SPI resource set with the SPI/RRF multiplexing interface (ZH1.5-7P) at the hardware level. Connecting both simultaneously will cause abnormal device operation.

M2WE Interface Warning

The onboard M2WE expansion interface uses a FLY proprietary protocol. It is absolutely forbidden to connect any standard or unofficial M.2 device, otherwise it will cause permanent hardware damage to the motherboard.

Loading...