Onboard 5V Fan Interface

Onboard 5V Fan Wiring

• The Pi-V2 has a 5V controllable interface for main controller cooling. The wiring method is as follows:

Commands to execute via SSH before adding configuration

• FAST system does not require this step

wget https://cnb.cool/3dmellow/public/static-files/-/git/raw/main/host/linux-dtb-current-fly-sunxi64_3.3.5_arm64.deb && sudo dpkg -i linux-dtb-current-fly-sunxi64_3.3.5_arm64.deb
sudo reboot

Reference Configuration

[mcu host]                      # FlyOS has already generated the linux MCU for you, define it to use           
serial: /tmp/klipper_host_mcu 

[temperature_sensor FLY-Pi]      # Host computer temperature
sensor_type: temperature_host


[temperature_fan core_fan]      # Host computer cooling fan
pin: host:gpiochip1/gpio103     # Host computer fan pin
max_power: 1.0
sensor_type: temperature_host   # Set to host controller temperature
control:watermark               # Control method
target_temp: 48                 # Host computer cooling fan start temperature
min_temp: 0                     # Minimum temperature, an error will be reported if below this
max_temp: 90                    # Maximum temperature, an error will be reported if above this
off_below: 0.10
kick_start_time: 0.50
max_speed: 0.8                  # Maximum speed, 80% of full power
min_speed: 0.3                  # Minimum speed, 30% of full power