Skip to main content

Main Board Precautions

Power Indicator​

  • When powered only by TYPE-C and not connected to other main board power, at least two lights 3.3V and 5V should be on.
  • After connecting the main board power, the main board power light should light up 3.3V, 5V, and 12V.
  • Only after the drive power 0-2, drive power 3-7, and hotbed power are connected, will the power indicator lights on the lower left of the main board light up normally.

Troubleshooting​

Note
  • With no external devices connected (drives, limit switches, 12864, etc.)
  • When powered only by TYPE-C, at least two LEDs, 3.3V and 5V, should remain constantly on.
  • If 3.3V and 5V do not light up, check the main board's 5V jumper.
  • If the issue persists after replacing the jumper and confirming that the type-c is supplying power normally, contact customer service for after-sales support.
  • If one of the lights 3.3V, 5V, or 12V is blinking, it indicates a chip short circuit; contact customer service for after-sales support.

Drive​

  • Pay attention to the drive power, which is divided into two circuits: the first circuit powers drives 3-7, and the second circuit powers 0-2.
  • The main board supports external drives Wiring and Configuration Guide

Limit Switch Port​

  • Except for the last drive port (Drive7), which has an infinite limit switch jumper, all other drive ports have their infinite limit switch directly connected to the limit switch port.
  • If the limit switch port does not work, you can replace the limit switch port or trim the infinite limit switch foot of the drive.