Skip to main content

Motherboard ID Reading and Viewing

tip

Please do not modify the configuration when translating on the web.

Notice

Please do not modify the configuration when translating on the web.

Note

Please do not modify the configuration when translating on the web.

  • Please prepare a data cable with data transfer capability. If the length is particularly long, it is recommended to use a cable with a magnetic ring.

    Search for USB Tutorial​

    Precautions before searching for devices​

    • Before searching for the USB ID, please first connect to SSH
    • Please note that it is necessary to ensure that the SSH is logged in using the network rather than the serial port.
    • Please ensure that the motherboard with the USB firmware flashed is connected, and ensure that the data cable connecting the upper computer has a data transmission function.

    Search for devices​

    • Please ensure that the upper computer can be connected to the network normally, and ensure that the data cable connecting the lower computer to the upper computer has a data transmission function.
    • After connecting to the upper computer via SSH, enter lsusb and press Enter. If the information circled in the image below appears, you can proceed to the next step.
      • If there is no information feedback, this is a system problem of the upper computer, and we are powerless. You need to replace the system with a confirmed normal one or replace the upper computer.
      • If the lsusb command is not found, you can execute this command to install it: 
        sudo apt-get install usbutils
    • 1d50:6177 is the device you need to use this time. The suffix OpenMoko, Inc. stm32f407xx has a certain reference value, but it is not used as a judgment basis.
      • Some upper computers may have incomplete or no display due to system problems.
      • If the lsusb command can display the device, but there is no 1d50:6177, please try to change the data cable and try to connect the motherboard to other USB ports of the upper computer.
    • If you have previously performed the above steps and successfully burned the Klipper firmware, and the motherboard is operating normally, but only need to update the Klipper firmware, please directly view the Firmware Update chapter in the right sidebar of this page.
    Precautions

    The next step can only be performed after the 1d50:6177 device is found.

    Search for USBID​

    ls /dev/serial/by-id/*
    • Enter the following command and press Enter. If everything is normal, a blue ID will appear in the following line. (The following is just for reference)
    • If there is no ID after entering the following command, but there is a device in lsusb, please replace the upper computer or the upper computer system.
    Precautions

    If multiple IDs appear, please select the corresponding ID according to the MCU model of your motherboard.

    Fill in the USB ID in the configuration​

    • Open the printer web interface, find in the configuration options on the left sidebar: for fluidd: {…}; for mainsail: Machine, click to enter, and you can find printer.cfg.

    • Copy the blue ID and fill it in the serial: of the [mcu] node in the printer.cfg configuration. After saving and restarting, the motherboard can be connected. If Klipper prompts ADC out of range, it is a normal phenomenon. Connect the heated bed and the thermistor, configure the thermistor pins and output pins of the nozzle and the heated bed, and then save and restart.

    dangerous

    Note: All IDs appearing in the document are examples. The actual ID of each motherboard is different. Please modify and fill in according to the ID actually obtained.