Tip

• Super8 PRO uses a TF card for firmware flashing by default.
• Please prepare a TF card with a capacity no larger than 32G.
• Non-brand memory cards may cause flashing failures. Please try to use the recommended memory cards below to update the firmware.
• The transfer speed of the TF card should preferably be class10 class or class10 class or higher. It is recommended to use TF cards from brands such as SanDisk.

Firmware Flashing Instructions

Tip

• The Super8 Pro comes with the TF card bootloader pre-flashed from the factory. There is no need to flash it again yourself.

Selecting the Firmware Type

Please confirm the connection method first

• If not using a CAN tool board: select USB firmware.
• When a CAN tool board is required: select USB-to-CAN Bridge Firmware.
• Only one of the two firmware types can be selected. Do not flash both simultaneously. The Super8 Pro firmware is flashed using a TF card.

Firmware Type	Applicable Scenario	Advantages	Confirm Before Selecting	Operation
USB Firmware	When not using a CAN tool board	Stable communication, simple configuration	If not using a CAN tool board, use the USB firmware	Compile USB Firmware
USB Bridge to CAN Firmware	When a CAN tool board is required	Can connect multiple CAN devices, reduces USB usage	Select only when a CAN tool board is required; confirm CAN wiring, terminal resistors, and CAN baud rate configuration are consistent	Compile USB Bridge to CAN Firmware