Skip to main content

BL Firmware

tip
  • Please note that the bootloader is pre-flashed at the factory and does not need to be re-flashed.

Entering Flash Mode​

tip

The right button is the BOOT button, and the left button is the RESET button.

  • There are two methods to enter flash mode.
  • First method: With the tool board completely powered off, hold the BOOT button, then connect a data-capable TYPE-C cable from the mainboard to your device.
  • Second method: After connecting a data-capable TYPE-C cable from the mainboard to your device, hold the BOOT button, then press and release the RST button, and finally release the BOOT button.
    Loading...

Flashing Firmware​

  • Katapult firmware for E3-PRO-Ultra
    • Click the download link below.
    • Loading...
Important Notice

To ensure successful STM32 flashing, please pay attention to the following:

  • Some computer USB ports may have driver or signal compatibility issues, leading to unstable flashing. It is recommended that you try connecting to a different USB port.
  • If changing ports does not work, an effective solution is to connect via an external USB hub, which often improves compatibility.
  • When the flashing software reports the error message shown below, also try using a hub first. If the problem persists, please check or use the host computer software for flashing.
    Loading...
  1. Flashing Tool Download Link
  2. Download SetupSTM32CubeProgrammer and the STM32 DFU Driver.
  3. Download the firmware to any directory on your computer.
  4. Connect the mainboard to the computer using a Type-C cable. Ensure it has entered DFU flashing mode.
  5. In STM32CubeProgrammer, select USB mode, refresh, and connect.
    Loading...
  6. If no error pop-up appears, the connection is successful.
    Loading...
  7. Click the download icon on the left and select the options shown below.
    Loading...
  8. Click the Browse button indicated by the arrow, then select the firmware you need to flash.
    Loading...
  9. For Start address, enter 0x08000000.
    • Note: If the firmware is in HEX format, please skip this step!!
    Loading...
  10. Click Start automatic mode below to begin flashing the firmware.
    Loading...
  11. The prompt below indicates that the firmware flashing is complete.
    Loading...
tip

After flashing is complete, you need to completely power off the mainboard once.

Loading...