Connect to Host Computer via SSH

• You can connect to the device using serial port or WIFI.
• Please prepare MobaXterm_Personal or other SSH terminal tools in advance.
• Please ensure that the SD card or M2WE has burned the system corresponding to the host computer.
• If the host computer cannot start up normally, please remove all peripherals such as drivers, limit switches, and fans!
• Finally, please connect to SSH via the network for firmware compilation!
• For firmware compilation, refer to the tutorial on connecting to the host computer via WIFI or Ethernet.

Serial Connection

Use Serial Port to Connect to Host Computer SSH

• Use a USB Type-C cable to connect the upper computer of FLY with the computer.
• For other upper computers, please query the connection method yourself!!

FLY-C5

• Ports of FLY-C5

• If the motherboard is connected to the computer normally, you will see the CH340 port in the Device Manager.

• Open MobaXterm, set it up as follows, and select the port seen in the Device Manager.

• If everything is normal, you can see the boot screen.

• After a moment, this screen indicates that it has started.

If after several minutes, there is no display as shown below, press the Enter key a few times.

After pressing Enter, the following content will appear.

• If you need to view the IP address, enter ip a | grep inet in SSH and press Enter. Find the IP address in the same segment as your router to access.

Network Connection

Use Network IP to Connect to Host Computer SSH

• Please log in to the router backend connected to the upper computer.
• Please ensure that the system has started normally.
• Please ensure that you know the username and password of the upper computer, the default username for the FLY system is fly, and the default password is mellow.
• If the motherboard has started and is connected to the network, you can use the IP to connect to SSH.
• Open MobaXterm, set it up as follows, fill in the IP address previously viewed, or check it in the router backend.

Note: Here, step 4 inputs the username of the upper computer.

• The first connection will pop up this window, click Accept to proceed.

• Prompt to input the password, press Enter after entering the upper computer password.

Note: Here, the entered password is invisible, just press Enter directly after typing.

The default username for the FLY system is: fly, and the password is: mellow.

• Login successful.

---