SSH connection to host computer

dangerous

• This document is only applicable to FLY host computer
• If you are compiling and burning the firmware, please refer to the network connection tutorial instead of the serial port connection tutorial

• You can connect to the device via serial port or WIFI
• Please prepare MobaXterm_Personal or other SSH terminal tools in advance
• Please make sure that SD card or M2WE has been burned with the corresponding host computer system
• If the host computer cannot start normally, please remove the driver, limit switch, fan, and other peripheral devices!!
• Finally, connect to SSH via network for convenient firmware compilation!!
• If you need to compile the firmware, please see the tutorial on connecting the host computer via WIFI or Ethernet

Install system card

• Make sure the system card has been burned with the corresponding system, otherwise it will not start

M2WE installation diagram to C5

TF card installation diagram to C5

Power supply

• Use USB Type-c cable to connect the FLY host computer to the computer
• Make sure that USB Type-C supports data transfer!
• After the system starts, the indicator light will flash rapidly!!
• Flashing indicates that the system has started
  

Serial Connection

Connecting to Host Computer SSH via Serial Port

• If the motherboard is properly connected to the computer, you can see the CH340 port by opening the Device Manager

• Open MobaXterm and set it up as shown below. Select the port previously seen in the Device Manager

• Please note that Speed(bps)* should be set to 115200

• If everything is working properly, you will see the boot screen
• After a short wait, the screen shown below means the system has started

If after waiting a few minutes, the screen appears as shown below without any display, simply press the Enter key several times

• Please note that if it is the FAST system, you need to enter a username and password, and the password will not be visible as you type

• FlyOS-FAST default username is root, and the default password is mellow

• After pressing Enter, the following content will be displayed

  

tip

• The appearance of the screen below indicates successful login
• The FAST system updated the appearance below in version V1.3.0

• If you need to check the device IP, ensure that the Ethernet cable is connected or the WIFI is properly connected Connect to WIFI

Network Connection

Connecting to Host Computer SSH via Network IP

• Please log in to the router admin panel to which the host computer is connected, unless you already know the host computer's IP address
• Please ensure that you are aware of the host computer's username and password
• FlyOS-FAST default username is root, and the default password is mellow
• If the motherboard has already booted and is connected to the network, you can use the following method to connect to SSH
• Open MobaXterm and set it up as shown below. Enter the IP address previously checked, which can also be found in the router admin panel

Note: In step 4 here, enter the username of the host computer

• When connecting for the first time, this window will pop up. Click Accept to proceed

• When prompted for a password, press Enter after entering the host computer's password

Note: The password entered here will not be visible. Simply press Enter after typing it in

• For the FLY-FAST system, the username is: root, and the password is: mellow

tip

• The appearance of the screen below indicates successful login
• The FAST system updated the appearance below in version V1.3.0

• Successfully logged in