Skip to main content

Introduction to Halo Page Operations

Page Structure​

  Print Files Page           Home Page             Extrude Page            System Service             Settings              Device Information
+-------------+    +-------------+    +-------------+    +-------------+    +-------------+    +-------------+
|             |    |             |    |             |    |             |    |             |    |             |
| Print Files |<-->|     Home    |<-->|   Extrude   |<-->| Sys Service |<-->|   Setting   |<-->|  Dev Info   |
|             |    |             |    |             |    |             |    |             |    |             |
+-------------+    +-------------+    +-------------+    +-------------+    +-------------+    +-------------+
                         ∧
                         |
                         ∨
                   +-------------+
                   |             |
                   | Blocking Det|
                   |             |
                   +-------------+
                     Blocking Detection Page
            (This page appears only when blocking detection is enabled in settings)

Home Page​

  • The operable areas in the image above correspond to the numbers below
  1. Click: Enter the extrusion temperature setting, adjust the temperature by dragging the ring bar, and click the area 1 again to confirm the set temperature
  2. Click: Enter the hotbed temperature setting, adjust the temperature by dragging the ring bar, and click the area 2 again to confirm the set temperature

Extrude Page​

  • The operable areas in the image above correspond to the numbers below
  1. Click: Increase the extruder head target temperature by 1
  2. Long press: Enter the extrusion temperature setting, adjust the temperature by dragging the ring bar, and click again to confirm the set temperature
  3. Click: Decrease the extruder head target temperature by 1
  4. Click: Extrude
  5. Swipe up/down: Select the length of extrusion or retraction, unit mm
  6. Click: Retract
  7. Long press: Enter the extrusion speed setting in the image above, swipe up/down to select the extrusion speed, unit mm/s, and click the surrounding blank area to exit

System Service Page​

  • Click the corresponding service in the image above to pop up the window in the image below, where you can start, restart, or close the corresponding system service
  • Subsequent OTA will support all services that can be operated in Moonraker

Settings Page​

  • To be updated