Skip to main content

Introduction to Halo Page Operations

Page Structure

  Print Files Page           Home Page             Extrude Page            System Service             Settings              Device Information
+-------------+ +-------------+ +-------------+ +-------------+ +-------------+ +-------------+
| | | | | | | | | | | |
| Print Files |<-->| Home |<-->| Extrude |<-->| Sys Service |<-->| Setting |<-->| Dev Info |
| | | | | | | | | | | |
+-------------+ +-------------+ +-------------+ +-------------+ +-------------+ +-------------+

|

+-------------+
| |
| Blocking Det|
| |
+-------------+
Blocking Detection Page
(This page appears only when blocking detection is enabled in settings)

Home Page

  • The operable areas in the image above correspond to the numbers below
  1. Click: Enter the extrusion temperature setting, adjust the temperature by dragging the ring bar, and click the area 1 again to confirm the set temperature
  2. Click: Enter the hotbed temperature setting, adjust the temperature by dragging the ring bar, and click the area 2 again to confirm the set temperature

Extrude Page

  • The operable areas in the image above correspond to the numbers below
  1. Click: Increase the extruder head target temperature by 1
  2. Long press: Enter the extrusion temperature setting, adjust the temperature by dragging the ring bar, and click again to confirm the set temperature
  3. Click: Decrease the extruder head target temperature by 1
  4. Click: Extrude
  5. Swipe up/down: Select the length of extrusion or retraction, unit mm
  6. Click: Retract
  7. Long press: Enter the extrusion speed setting in the image above, swipe up/down to select the extrusion speed, unit mm/s, and click the surrounding blank area to exit

System Service Page

  • Click the corresponding service in the image above to pop up the window in the image below, where you can start, restart, or close the corresponding system service
  • Subsequent OTA will support all services that can be operated in Moonraker

Settings Page

  • To be updated