Product Introduction
- The main controller adopts ESP32-S3R8, offering stronger performance than ESP32. It features 8MB PSRAM and 16MB Flash. The screen is an IPS display with high resolution, high brightness, wide viewing angles, delicate colors, and supports capacitive touch.
Product Features
- Currently there are 7 pages in total, swipe left, right, up, and down to switch.
-
Print Files (browse the print file list)
-
Home (displays standby, printing, shutdown, error, and other statuses)
-
Extrude (control extrusion, retraction, extrusion temperature)
-
System Services (control the start, stop, and restart of services such as the host, Klipper, Moonraker, etc.)
-
Settings (used to configure various halo parameters, wifi, ip, language, backlight brightness, etc.)
-
Device Information (displays halo information, firmware version. Check for updates, etc.)
-
Filament Jam Detection: filament break and jam detection, filament length detection; after a specified length of filament jam, it can automatically pause and pull GPIO47 high (disabled by default; this page will only appear after filament jam detection is enabled in settings)
In addition, the "Shutdown After Print" feature can be enabled in settings: after printing is completed, the host will be shut down after a set delay and GPIO48 will be pulled high (disabled by default).