Skip to main content

FLY-ALPS Firmware Flashing

Applicable Versions

This documentation applies to devices with a firmware version lower than v2.0.0. If your firmware version is at or above this version, please refer to the Firmware Update documentation to update directly via the web tool, without entering DFU mode.

Check Firmware Version​

You can view the current firmware version number after connecting the device via the Web Tool.

Firmware Download​

Firmware can be obtained through the following link:

Enter Flashing Mode (For Flashing BOOT Firmware)​

You can put the device into flashing mode using either of the following methods:

  • Method 1:

    1. Connect the device to your computer using a Type-C cable.
    2. Press and hold the BOOT button on the device, briefly press the RESET button, then release the BOOT button.

  • Method 2:

    1. Press and hold the BOOT button on the device.
    2. Connect the Type-C cable to the device and the computer, then release the BOOT button.
Loading...

Flash Complete Firmware​

The FLY-ALPS BOOT firmware is located in the following path within the archive:

FLY-Firmware/ExtensionBoard/ALPS/mergedBL

For the general flashing method, please refer to the link below:

Please refer to this link for firmware updates

Caution

Do not disconnect the Type-C connection during the flashing process, as this may cause the flashing to fail.

Next Steps​

After the BOOT firmware is flashed, the device will support direct updating of the main firmware via the web tool, without needing to enter DFU mode again.

Please refer to the Firmware Update documentation to complete the main firmware update.

Loading...