Skip to main content

Connect to RRF

Important note
  • AirClick must be connected to the same network as the target printer.
  1. Click on the System Settings on the left.
  1. Select RRF for Printer Type.
  2. Enter the IP address of the RRF machine in RepRapFirmware IP.
  1. After configuring as shown in the above figure, click Submit in the lower right corner to save the configuration.
  2. After a correct connection, a prompt will appear at the top of the web page.
  1. If the connection fails:
    • Check if the IP address is correct.
    • Check if the printer and AirClick are connected to the same network.
    • Check if the RRF motherboard is operating normally.
    • Check if the browser can open the web page of RRF.