Skip to main content

Connecting to the Network via SSH

  • Please ensure that the system has started and is connected to the host machine via SSH using a serial port, it is recommended to use MobaXterm_Personal
  • Please ensure that the host machine has installed M2WE or 2.4G_WiFi module, if it is Lite2 or MiniPad, no module installation is required
  • Please note that the 2.4G_WiFi module, Lite2, and MiniPad can only use 2.4G WiFi and cannot use 5G WiFi
  • Please note that the network cannot use dual-band fusion, otherwise normal connection cannot be achieved
  • Please ensure that the antenna is fully installed!!!
  1. After entering the nmtui command in the SSH software and pressing Enter, the interface shown in the figure below will appear
  1. Press Enter then select Activate a connection and press Enter again
  1. Select the network you need to connect to, press Enter, input the WiFi password, and then select OK to save the connection
  1. After connecting to WIFI, find and press the Esc key several times to exit the current interface, then enter ip a and press Enter

  • In the figure, 192.168.2.136 is the IP address of the host machine