Introduction
FLY TOOL-LITE-CAN is a tool board designed by Guangzhou Meilun Electronic Technology Co., Ltd. for 3D printers. This tool board provides xt30/kf interfaces, which can replace the complicated wiring between the original mainboard and the print head with four wires, optimizing the layout. TOOL-LITE-CAN is suitable for 36/42 stepper motors, and it integrates a CANBus transceiver, Type-C port, TMC2209 driver, LIS2DW accelerometer, 2 controllable fans, and other functions into the tool board. This tool board is suitable for Klipper firmware.
Pinout
- This page lists the pinout of the FLY Tool-Lite CAN tool board after flashing Klipper firmware. The pin numbers are based on the product schematic.
CAN Firmware Compilation and Burning
Start Compilation
Mainboard Reference Wiring
{/ flyos-pin-notice /}
参考配置
请不要在打开网页翻译时修改配置
ID Search Tutorial
Please do not modify the configuration while web page translation is enabled.
Accelerometer Usage
Usage Tutorial
Bootloader Recovery (Unbricking)
FLY-TOOL-LITE CAN comes with Katapult pre-flashed from the factory. Do not re-flash the firmware on this page during normal use or when updating Klipper firmware; this page is only for unbricking recovery after the Bootloader is corrupted.
3D Models and Schematics
* This document provides the following materials