Introduction
FLY TOOL-LITE-232 is a tool board designed for 3D printers by Guangzhou Meilun Electronic Technology Co., Ltd. This tool board provides XT30/KF interfaces, allowing four wires to replace the complicated wiring between the original mainboard and the printhead, optimizing the layout. TOOL-LITE-232 is suitable for 36/42 stepper motors. It integrates an RS232 transceiver, a Type-C port, TMC2209 driver, LIS2DW accelerometer, 2 controllable fans, and other functional tool board features. This tool board is suitable for Klipper firmware.
Pinout
- This page lists the pinout of the FLY Tool-Lite 232 tool board after flashing Klipper firmware. The pin numbers are based on the product schematic.
Mainboard Reference Wiring
* Below is the reference diagram for dial mode. The mainboard reference wiring diagram is being supplemented.
RS232 Firmware Compilation and Burn
Start Compilation
参考配置
请不要在打开网页翻译时修改配置
ID Search Tutorial
Please do not modify configurations when the webpage translation is enabled.
Accelerometer Usage
Usage Guide
3D Models and Schematic Diagrams
* This document provides the following materials