Introduction
The FLY-SHT36-LIS3DH is a nozzle tool board designed by Guangzhou Meilun Electronics Technology Co., Ltd. for the extruder of 3D printers. By using this tool board, four wires can replace the complex wiring between the original motherboard and the print head, optimizing the layout. The FLY-SHT36-LIS3DH is suitable for 36 stepper motors and integrates a CAN transceiver, USB port, TMC2209 driver, LIS3DH acceleration sensor, two controllable fans, and other features. This tool board is compatible with the Klipper firmware.
Pinout
- This page lists the pinout of the FLY-SHT36 (LIS3DH) tool board after flashing the Klipper firmware. The pin numbers are based on the product schematic.
SHT36 LIS3DH Firmware Compilation and Flashing
3 items
Tool board ID read view
- Before searching for the ID, use an XT30 data cable to connect the tool board to the UTOC or a motherboard flashed with bridge firmware; below is the reference wiring diagram.
Motherboard Wiring
The included blue heatsink should be attached to the driver!!!
参考配置
Accelerometer Usage
Update Klipper
3D Models and Schematics
* This document provides the following: