Introduction
* V1
Pinout
- This page lists the pinout of the FLY-SB2040 toolboard after flashing the Klipper firmware. Pin numbers are based on the product schematic.
SB2040 Firmware Compilation and Flashing
3 items
Tool board ID read view
- Before searching for the ID, use an XT30 cable to connect the tool board to the UTOC or a motherboard with bridge firmware flashed. Below is the reference wiring diagram.
Wiring Reference
* The heat sink is attached to the driver!
配置参考
Accelerometer Usage
Usage Tutorial
3D Models and Schematics
* This document provides the following