📄️ Introduction
* We are pleased to release the brand-new FLY-π motherboard. This board can run as a host computer, replacing Raspberry Pi, and it features onboard 1GB DDR3 memory.
🗃️ System Image Burning
2 items
📄️ SSH Connecting to the Host Computer
* This document is applicable only to the FLY host computer
📄️ Connect to WIFI
Install the antenna on the PI
📄️ Power Supply for Host Computer
There are two power supply methods for FLY-Pi-V2.
📄️ Accelerometer usage
Mainboard wiring
📄️ Screen Wiring and Configuration
Screen Wiring
📄️ Onboard 5V Fan Port
The Pi has an onboard 5V controllable interface used for main controller heat dissipation. The wiring method is shown in the figure below
📄️ Using the Onboard CAN HAT
* Please note that the CAN HAT has been discontinued.
📄️ 40PIN Onboard Header Diagram
📄️ I2C Usage
* Use the I2C interface on the 40PIN up board
📄️ 3D Model and Schematic
* This document provides the following