📄️ Introduction
Mellow Fly-D8 is a high-performance 3D printer motherboard launched by the Fly3D motherboard R&D team of Guangzhou Meilun Electronic Technology Co., Ltd., supporting up to 8 stepper motors.
🗃️ FLY-D8-PRO firmware compilation and flashing
5 items
📄️ Onboard DIP Switch Introduction
* When the dip switch is toggled to the right, it will enable the USB port next to the Type-C port
📄️ Wiring Reference
PIN Description
📄️ Klipper配置参考
📄️ CAN Bridge
The CAN bus is a serial communication protocol bus used for real-time applications. It can use twisted pair to transmit signals and is one of the most widely used fieldbuses in the world. The CAN protocol is used for communication between various components in automobiles, replacing expensive and cumbersome wiring harnesses. The robustness of the protocol has extended its use to other automation and industrial applications. The characteristics of the CAN protocol include integrity of serial data communication, real-time support, a transmission rate of up to 1Mb/s, 11-bit addressing, and error detection capabilities.
📄️ RS232 Connection
The RS232 standard interface (also known as EIA RS-232) is one of the commonly used serial communication interface standards, widely used for data transmission between various devices. Its stability and reliability make it the preferred communication method for many devices. This protocol uses signal levels different from the standard 5V to transmit wire data, which can minimize signal interference to the greatest extent. In the 3D printer system, compared to CAN, RS232 has a higher data transmission rate, better stability, simpler configuration, and better compatibility with the host computer.
📄️ 3D Model and Schematic Diagram
* This document provides the following