📄️ Introduction
BD Sensor is a distance sensor that can be used with 3D printers to perform fast bed leveling and Z-axis adjustments in real time.
📄️ Installation Guide
BDsensor-m can directly use the EXP1 and BL-TOUCH* interfaces on the mainboard
📄️ klipper usage
Connect the sensor cable to the EXP1 interface of the mainboard
📄️ Using Marlin
Connect the sensor cable to the EXP1 interface on the motherboard
📄️ Klipper Auto Z-OFFSET
This feature requires the BD Sensor firmware version (you can obtain this version by sending M102 S-1, not the hardware version on the sensor) to be V1.1b, greater than V1.2b, or purchased after March 2024; otherwise, you will need to use an external hardware tool (such as an STlink) to flash the firmware into the BD Sensor.
📄️ Marlin Auto Z-OFFSET
This feature requires the BD sensor firmware version (you can obtain this version by sending M102 S-1, not the hardware version on the sensor)