Introduction
Product Features
Firmware Update
* The device comes pre-flashed with firmware from the factory.
Connect to WiFi
* The onboard antenna of this product can only be used for receiving. The transmitting antenna needs to be installed separately, with the antenna terminal being ipex3.
Connecting to Klipper
* AirClick must be connected to the same network as the target printer
Connect to RRF
* AirClick must be connected to the same network as the target printer
Connect to BambuLab
* AirClick must be connected to the same network as the target printer
Button Addition
* The wireless button requires battery installation, the battery model is CR927
Wired Connection Klipper Configuration
* You need to flash the firmware to STM32F072 before connecting to Klipper, otherwise wired connection operation is not supported.
D Models
AirClick 3D Model