📄️ Introduction
Product Features
📄️ Firmware Update
* The firmware has been pre-flashed at the factory
📄️ Connect WiFi
* The built-in antenna of this product can only be used for receiving. The sending antenna needs to be installed by yourself, and the antenna terminal is ipex3.
📄️ Connect to Klipper
* AirClick must be connected to the same network as the target printer
📄️ Connect to RRF
* AirClick must be connected to the same network as the target printer
📄️ Connect to BambuLab
* AirClick must be connected to the same network as the target printer
📄️ Add Button
* The wireless button requires a battery to be installed, the battery model is CR927
📄️ Wired Connection Klipper Configuration
* Need to flash the STM32F072 firmware and connect to klipper, otherwise wired connection operations are not supported
📄️ 3D Model
AirClick 3D Model