Skip to main content

SHT36 V3 Onboard DIP Switches and Firmware Instructions

Firmware Instructions​

tip
  • Pre-flashed with Katapult (CAN) firmware at a baud rate of 1M.
  • For other configurations (e.g., CAN baud rate 500K), you can flash it yourself.
  • Katapult Firmware Flashing

Firmware Flashing Steps and DIP Switch Settings​

1. CAN Firmware (Klipper)​

  • DIP Switch Settings:

    Loading...

  • Preparation for Flashing: Before flashing, ensure the CAN cable is connected between the tool board and the mainboard, and the 12V-24V power supply is connected.

2. RS232 Firmware (Klipper)​

  • DIP Switch Settings:
    Loading...
  • Flashing Steps: First, flash the compiled firmware via the tool board's USB port, then connect the CAN cable.

3. RRF-CAN Firmware​

  • DIP Switch Settings:
    Loading...
  • Flashing Steps: Flash the RRF firmware via the tool board's USB port, then connect the CAN cable.
Loading...