Skip to main content

klipper

Tip

Firmware has been pre-flashed before shipping, but a manual update is recommended.

Wi-Fi Connection and Basic Operations​

7-inch Wi-Fi Capacitive Touch Screen Controls Multiple Machines

Klipper Configuration​

LED Configuration​

[led LED]
white_pin:PA15

PTC/Thermistor Configuration​

[heater_generic warehouse]
heater_pin:E_CS
sensor_type:ATC Semitec 104GT-2
sensor_pin:PA1
min_temp:-270
max_temp:600
control:watermark

FAN Configuration​

[fan_generic fan1]
pin: FAN1
[fan_generic fan2]
pin: FAN2

Custom G-code​

  • Pull down the screen to access custom G-code.
  • Format for sending multiple G-code commands with one button:
  • Example:
G91 
G1 X10 F6000
G90
  • Input format on the screen: (Starting from the second line, add \n before each command)
G91\nG1 X10 F6000\nG90

Multiple Device Connection​

  • Moonraker needs to be replaced

  • Please connect to SSH first, and make sure the network is working properly

  1. Stop the Moonraker service
sudo systemctl stop moonraker
  1. Back up the Moonraker files
mv ~/moonraker ~/moonraker-bak
  1. Pull Moonraker
git clone https://cnb.cool/3dmellow/public/moonraker -b dev-flyos moonraker
  1. Access the host computer in the browser, find moonraker.conf and add the following, then restart the system
[network]
  1. Then enter the address below in the browser, where the IP needs to be replaced with the IP of the host computer
http://ip:7125/server/network/wifi/scan

  • The appearance of this step indicates that the operation is complete

    Loading...
Loading...