Skip to main content

🚀 Quick Start

🎯 Guide Objective: Complete the system deployment and firmware flashing for the Fly-PI V3 mainboard within 30 minutes, bringing it to a state where it can connect to Klipper and perform basic tests.
✅ Completion Criterion: Access the Klipper interface via a web browser.

📍 Important Notes
  • 📦 Required Accessories: Fly-PI V3 must be used with Fly-M2WE or a TF card, otherwise the system cannot boot.
  • ⚡ Power Requirements: Input voltage range 12V-24V, do not exceed this range.
  • 🔌 Safe Operation: Always disconnect power before performing any wiring operations! When flashing firmware, please follow the guide's instructions.
  • 🔧 Tool Preparation: Prepare basic tools such as screwdrivers and data cables in advance.

📦 Step 1: Prepare Tools and Resources​

Loading...


📝 Included Content
  • MobaXterm (for connecting to the host)
  • CH340 (serial port driver for system connection)
  • Panasonic_SDFormatter (for formatting TF cards)
  • SetupSTM32CubeProgrammer (for flashing the lower computer firmware)

🖥️ Step 2: Install System and Basic Configuration​

1. System Image Flashing​

2. System Basic Configuration​

3. Network and Remote Connection​

4. Display Device Configuration​

5. Host Power Supply​


📝 Notes for This Step
  • Ensure the TF card or M2WE is correctly formatted before flashing the image.
  • The first system boot may take 3-5 minutes; please be patient.
  • Default SSH credentials: username: root, password: mellow.
  • Screen configuration is only necessary if you have a screen device.

📈 Step 3: Extended Features and Advanced Configuration (Optional)​

The following features can be configured step by step as needed after completing the basic setup and ensuring the printer can operate normally:

Camera Usage​


External Tool Board​

External Fan​

Resource Download​

  • It is recommended to configure and test extended features one by one to avoid changing too many parameters simultaneously.
  • Camera configuration requires an additional USB camera device.
  • Resonance compensation requires an accelerometer sensor.
  • Tool board connection is suitable for multi-toolhead 3D printers.
Loading...