Introduction

We are excited to release the brand-new FLY-Pi V2 host computer. This board has the same installation dimensions as the Raspberry Pi and can replace the Raspberry Pi as a host computer. It features 1GB of onboard DDR3 memory.
This host computer can run Klipper and RRF firmware, and even supports Klipper Screen when using the SHT tool board.

Same form factor as Raspberry Pi 3B and 4B
CPU: High-performance Allwinner H5 chip, 4-core 64-bit Cortex-A53
GPU: High-performance 6-core Mali 450, pixel fill rate greater than 2.7 Gpixels/s
RAM: 1GB DDR3 (shared with GPU) (512+512)
ROM: Supports up to 128GB SD card
Peripherals: SPI x2, UART x2, USB x4 (USB 2.0 x3, OTG x1), Micro HDMI x1, ETH x1 (100M), CAN (onboard USB-to-CAN module, i.e., onboard UTOC)
Interfaces: Onboard M.2 interface for expansion of WIFI, eMMC, etc. (private protocol; do not connect non-FLY π dedicated M.2 devices)
40Pin interface compatible with Raspberry Pi
Supports 12-24V DC power input for more stable power supply
A 5V fan ZH1.5 interface is reserved
The system comes pre-installed with klipper, moonraker, mainsail, fluidd, klipper-screen, Crowsnest, resonance compensation plugin, and numpy, no need for complex operations such as changing software sources, making it easier for beginners to get started (TF card or M2WE needs to be purchased)

Product Interface Description​