Connect to WIFI
Install the antenna on the MINI PAD
- The red arrow points to the WIFI antenna interface
- The WIFI antenna port is
ipex1
- Install the antenna on the MINI PAD, otherwise it may fail to connect to the internet due to poor signal

Notice
- The FLY host computer needs to use the M2WE module or the 2.4G WiFi module, otherwise WiFi cannot be used.
- Please note that Chinese name Wi-Fi and 2.4G and 5G dual-band combined Wi-Fi are not supported.
- If it is mini pad or lite2, please ignore this warning.
::
Connect Host Computer
- If configuring Wi-Fi fails under the BOOT disk, you can refer to this configuration for Wi-Fi connection. Note that a serial port connection to the host computer is required.
- First, use the serial port to connect to SSH.
- Execute the following command. You may be prompted to enter a password. Enter the password
mellow
and press Enter. Note that the password is invisible.
sudo nmtui

-
Select
Activate a connection
and press Enter. -
Enter the following interface. Use the arrow keys (
↑ ↓
) on the keyboard to select the Wi-Fi to connect to, then press Enter, input the password, and wait for the connection to succeed. -
After the connection is successful, as shown in the figure below.
-
Press the ESC key to exit and return to the command line interface. Enter
ip a
. The IP address192.168.2.126
in the figure is the IP address of the host computer.