Skip to main content

Connect to WIFI

Install the Antenna on LITE 2​

  • The red arrow points to the WIFI antenna interface.
  • The WIFI antenna port is ipex1.
  • Install the antenna on LITE 2, otherwise you may not be able to connect to the internet due to poor signal.
  • If you find that you are not connecting to WIFI normally, first check if the antenna is connected, and then use the method below to connect to WiFi.
Notice
  • The FLY host machine needs to use the M2WE or 2.4G WIFI module, otherwise use WIFI.
  • Please note that Chinese name WiFi and dual-band (2.4G and 5G) WiFi are not supported.
  • If you are using mini pad or lite2, please ignore this warning.

Connect to Host Machine​

  • If configuring WIFI under BOOT disk fails, you can refer to this configuration for WIFI connection. Please note that serial port connection to the host machine is required.
  • First, connect to SSH via serial port here.
  • Execute the following command, you may be prompted to enter a password. Enter the password mellow and press Enter. Note that the password is invisible.
sudo nmtui

  • Select Activate a connection and press Enter.

  • Enter the following interface, use the ↑ ↓ keys on the keyboard to select the WiFi you want to connect, press Enter, input the password, and wait for the connection to succeed.

  • After successful connection, it will look like the following image.

  • Press ESC to exit and return to the command line interface, then input ip a. In the image, 192.168.2.126 is the IP address of the host machine.