BL firmware

tip

• Please note that the bootloader has already been pre-flashed at the factory and does not need to be re-flashed.

Enter Programming Mode

• There are two methods to enter programming mode.
• Method 1: With the motherboard completely powered off, short-circuit the BOOT pin and connect the data transmission cable to both the motherboard and your device.
• Method 2: Connect the data transmission cable to both the motherboard and your device, then short-circuit the BOOT pin and press the RST button, release the RST button, and finally disconnect the BOOT jumper.
  

Flash Firmware

Windows flashing tutorial

• The bootloader firmware for SUPER8 Click to automatically download the firmware

Notice

• System compatibility issues, please use the computer's USB2.0 for burning
• If it still cannot be burned, please use an upper machine for burning

1. Burning tool Download link
2. Download SetupSTM32CubeProgrammer and STM32 DFU driver
3. Copy the compiled firmware (klipper.bin) or precompiled Katapult firmware to any directory on your computer
4. Connect the motherboard to the computer using a Type-C data cable, ensuring that it has already entered DFU burning mode
5. In STM32CubeProgrammer, select USB mode and refresh to connect
   
6. If no error pop-up appears, the connection is successful
7. Click the download icon on the left and select several options below
   
8. Click the arrow point to Browse, then choose the firmware you need to burn
   
9. Select Start address and enter 0x08000000
   
10. Click Start automatic mode below to start burning the firmware
    
11. The following prompt indicates that the firmware burning is complete
    

Host machine flashing tutorial

1. Install the programming tool

• No need to install the programming tool for the FLY upper computer.
• If you need to install it, please note: The upper computer needs to be connected to the internet to install successfully.
• If already installed, no need to install again.

sudo apt update
sudo apt install dfu-util -y

2. Execute the following command to check if the connection is successful.

lsusb

• If there is no DFU device, please try to re-enter programming mode.
• Due to system version issues, other names may be displayed. If 0483:df11 is shown, it indicates that the programming mode has been entered.

3. Pull the pre-compiled firmware

• These are all pre-compiled firmwares.
• Please note: The upper computer needs to be connected to the internet to install.
• The upper computer needs to execute the command below to download the firmware package.

cd && git clone https://github.com/FengHua741/FLY_Katapult.git

• If the firmware package has already been downloaded, it is recommended to update the firmware package before proceeding with the remaining steps.

cd ~/FLY_Katapult && git pull

4. Flash the firmware

tip

Only one firmware needs to be flashed.

• Below is the firmware flash command

  sudo dfu-util -a 0 -d 0483:df11 --dfuse-address 0x08000000 -D ~/FLY_Katapult/BL/SUPER/SUPER8.bin

5. When you see the content File downloaded successfully as shown in the image below, the flashing is successful.
   

tip

After flashing, the motherboard needs to be completely powered off once.