Firmware Burning Instructions
Notes
- PRO X10 comes pre-flashed with Katapult
- Once BL has been flashed, there is no need to flash BL again
- There are two types of BL for PRO X10, one for Katapult firmware and the other for BL flashed from TF card
- If needed, you can reflash BL according to your choice BL Firmware
Notice
- Mainboard firmware burning needs to be done through Katapult flashing Klipper
- If the mainboard has already been flashed with Katapult, there is no need to perform the final Katapult firmware burn, as that is just a precaution in case the Katapult firmware burn was not successful
- You can quickly press reset twice to see if an LED on the mainboard blinks, indicating that the mainboard has entered Katapult firmware
How to Determine Which Firmware You Need
tip
- Please note that you only need to flash one type of firmware
- Pro X10 can connect to the host computer using the following methods
-
USB Firmware
- Advantage: Reliable and stable communication
- Disadvantage: May affect data transmission if multiple USB devices are present
-
USB Bridge Firmware
- Advantage: Can connect multiple devices without occupying USB ports
- Disadvantage: May cause timeout errors or other issues when used with
KlipperScreen
Dip Switch Instructions
Please Note the Dip Switch Status

TF Card Slot Usage Instructions
