Introduction
FLY PRO_X10

Product Features
- Uses ARM Cortex-M7 series STM32H723ZGT6 main control chip with a 32-bit architecture and 550 MHz main frequency
- The motherboard connects to the core board via a BTB connector, compatible with core boards such as Orange Pi CM4 and Raspberry Pi CM4
- The motherboard reserves a BOOT button, allowing users to update the motherboard bootloader via DFU
- Ten pluggable TP drivers, no jumper required to switch between driver modes
- Onboard DIAG function pin, enables infinite position homing by simply plugging or unplugging a jumper cap
- Driver power supply supports HVIN and VIN power selection
- MCU firmware can be upgraded via MicroSD card, or updated via DFU using Klipper's make flash command
- Six dual-wire controllable fans, supports pluggable MOS, two four-wire fans, and one VCC fan
- CNC fan voltage options of 24V, 12V, and 5V to eliminate the need for external voltage conversion modules, thus reducing the chance of motherboard damage
- Uses replaceable fuses for convenient replacement;
Product Specifications
- MCU: STM32H723ZGT6
- Driver Power Supply: VIN(12V-24V),HVIN(12V-48V)
- Motherboard Power Supply: VIN(12V-24V)
- Hotbed Power Supply: BED IN(12V-24V)
- Heating Interfaces: Hotbed(BED OUT), Heating Rod (HETA0, HETA1, HETA2, HETA3)
- Driver operating modes supported: SPI, UART, STEP/DIR
- Expansion Interfaces: BLTouch (Servos, Probe), UART X1, High Voltage Endstop Port X1
Notes
Output Port | Maximum Current at 24V | Maximum Current at 12V |
---|---|---|
Hotbed Port | 15A | 7.5A |
Heater Port | 6A | 3A |
Fan Port | 1A | 0.5A |
Loading...