Skip to main content

🚀 Quick Start

🎯 Guide Objectives:Within 30 minutes, complete the system deployment and firmware flashing of the Fly-Gemini motherboard, bringing it to a state where it can connect to Klipper and perform basic tests.
✅ Completion Marker:Access the Klipper interface via a web browser and successfully connect to the Fly-Gemini motherboard.

📍 Important Notes
  • 📦 Required Accessories: The Fly-Gemini must be used with a Fly-M2WE or TF card, otherwise the system will not boot.
  • ⚡ Power requirements: Input voltage range is 12V-24V. Do not exceed this range.
  • 🔌 Safe Operation: When flashing firmware on the Before performing any wiring operations, be sure to disconnect the power supply!, also follow the instructions in the guide.
  • 🔧 Tool Preparation: Prepare basic tools such as screwdrivers and data cables in advance.

📦 Step 1: Prepare Tools and Resources​

Loading...


📝 Included Contents
  • MobaXterm (used to connect to the host computer)
  • CH340 (serial port driver used for system connection)
  • Panasonic_SDFormatter (used to format TF card)
  • SetupSTM32CubeProgrammer (used to flash the firmware of the lower computer)

🖥️ Step 2: Install the system and perform basic configuration​

1. System Image Flashing​

2. Basic System Configuration​

3. Network and Remote Connection​

4. Display Device Configuration​



📝 Instructions for this step
  • Before flashing the image, confirm that the TF card or M2WE has been properly formatted
  • The first system boot may take 3-5 minutes, please be patient
  • Default username for SSH connection: root, password: mellow
  • Screen configuration is only required on devices with a display

🔌 Step 3: Flashing Firmware and Device Identification​

Why is this step necessary? The previous step was to install the operating system on the host computer (compute module). This step is to flash the Klipper firmware onto the slave computer (the Fly-Gemini control board itself). The two must be paired to work together.

1. Firmware Explanation and DIP Switch Selection​

2. Flashing USB Firmware or CAN Bridge Firmware​

  • Choose the corresponding firmware to flash based on your connection method.
📝 Instructions for this step
  • When flashing firmware, ensure that the DIP switches on the motherboard are set to the correct position, otherwise the device will not be recognized.
  • The device ID is essential information required in the Klipper configuration. Please make sure to obtain it correctly.
  • If flashing fails, try to restore the Bootloader before flashing the main firmware.

🛠️ Step 4: Hardware Connection and Interface Configuration​

Power Off Operation

Before starting, completely shut down the printer and disconnect the power supply. Do not plug or unplug wiring harnesses, organize interface cabling, or touch terminals while the power is on.

1. Basic Hardware Connection​

2. Klipper Reference Configuration​

3. External Driver Connection and Configuration (Optional Feature)​

4. Motherboard Precautions​

📝 Instructions for this step
  • Strongly recommended: Before any wiring operation, ensure that the power supply is completely disconnected
  • Please make sure the power polarity is correct; reverse connection may damage the mainboard
  • Refer to your printer frame diagram for the motor wiring sequence
  • Check the temperature sensor connection before heating the heated bed and hot end

📈 Step 5: Extended Features and Advanced Configuration (Optional)​

The following features can be configured gradually as needed after completing the basic setup and ensuring the printer operates normally:

📝 Extended Features and Advanced Configuration

Camera Usage​

External Tool Board​

Resource Downloads​

  • It is recommended to configure and test extended features one by one to avoid changing too many parameters at once
  • Camera configuration requires additional USB camera device support
  • Resonance compensation requires an accelerometer sensor
  • Tool board connection is applicable to multi-tool-head 3D printers
Loading...