USB Firmware Compilation

Start Compilation

• A host machine with the installed klipper service is required Connect via SSH over the network
• Make sure the device is connected to the host machine
• Note: Please use a regular host machine, such as a Raspberry Pi FLY board, etc. If it's a modified host machine (e.g., WiFi stick, Redmi, etc.), due to too many issues, we cannot provide technical support for these machines

warning

• To switch from the ROOT user to a regular user, you can enter the command below
• Do not use the ROOT user
• For the fly user, you can directly enter: su fly. For non-fly users, please replace <your host machine username> with your host machine's username!

su <your host machine username>

::: tip

• Please ensure that the host machine can connect to the network normally.
• Before compiling the firmware, use SSH to log in to the host machine via the network.
• Do not use a serial port tool to log in to the host machine.

:::

Klipper Firmware Compilation and Configuration Page Operation Instructions

::: tip

Please make sure that the keyboard input method is in half-width mode, i.e., English mode.

:::

1. The key ↑ (up arrow) and ↓ (down arrow) on the keyboard are used to move the cursor up and down to select menu items.
2. The confirm key Enter or spacebar Space is used to check the menu or enter a sub-menu.
3. The exit key ESC is used to return to the previous menu.
4. The Q key is used to exit the Klipper firmware configuration page.
5. When exiting the Klipper firmware configuration page and there is a prompt, press the Y key to save the configuration file.

::: warning

If there are fewer options in the configuration page, please first check [ ] Enable extra low-level configuration options to display some hidden options.

:::

Below is the introduction on how to compile the firmware:

• After connecting to SSH, enter the following command and press Enter:

  cd ~/klipper && rm -rf ~/klipper/.config && rm -rf ~/klipper/out && make menuconfig

• Where rm -rf ~/klipper/.config && rm -rf ~/klipper/out is to delete previous compilation data and firmware, make menuconfig is for compiling the firmware, after execution, the following interface should appear

  

• Select Enable extra low-level configuration options and press Enter

  

• Enter the menu Micro-controller Architecture then select STMicroelectronics STM32 and press Enter

  

• Enter the menu Processor model, select STM32F407 and press Enter

  

• Select Bootloader offset, select: 32KiB bootloader

  

• Communication interface, select: USB (on PA11/PA12)

  

• Press the Q key, a Save configuration message will appear, then press the Y key

  

• Now the configuration should be saved and you should be back to the command line interface

• Enter make -j4 to start compiling, it takes some time

  

• If the output below appears, the compilation is successful

  Linking out/klipper.elf
  Creating hex file out/klipper.bin

Firmware Flashing

tip

Run the following command to flash the firmware

sudo fly-flash -d c8 -h -f ~/klipper/out/klipper.bin