Skip to main content

FLY_halo

1. Home

Tap the heated bed or hot end, swipe clockwise from the top center of the screen to the desired temperature, then tap the heated bed or hot end to set the temperature.

If you need to display the MCU temperature and host computer temperature, add this configuration

[temperature_sensor mcu]
sensor_type: temperature_mcu # Connect to MCU (default)

[temperature_sensor host] # Host computer temperature
sensor_type: temperature_host # Connect to host computer
Notes
  • The maximum temperature is set according to the configuration

2. Extrude

  • Press and hold the icon to set the hot end temperature, extrusion length, and extrusion speed
Notes
  • halo only supports control of a single hot end

3. System Services

Click on the service to pause, restart, or start

4. Settings

  1. Reset WIFI
  2. Reset KLIPPER IP
  3. Language selection
  4. Screen saver time, screen off time, backlight, screen rotation, and other functions

5. Device Information

Loading...
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -
- 3D Mellow -