Skip to main content

Connect to BambuLab

Important Note
  • AirClick must be connected to the same network as the target printer
  • Only LAN mode connection to BambuLab printer is supported
  1. Enable LAN Only Mode on the BambuLab printer

    • Turn on the BambuLab printer screen
    • Settings -> LAN Only Mode -> Enable
  2. Click on System Settings on the left

  3. Select BambuLab for Printer Type

  4. Click the Refresh Device List button

  5. Select the printer

    • If your printer does not appear after refreshing, you can choose to enter it manually. Enter the printer's IP address and serial number
  6. Enter the access code

    • The access code is the LAN mode access code of the printer, which can be viewed in the printer's settings as per step 1
  7. After configuring as shown above, click Submit at the bottom right to save the configuration

  8. A prompt will appear at the top of the web page if the connection is successful

  9. If the connection fails

    • Check if the IP address is correct
    • Check if the printer and AirClick are connected to the same network
    • Check if the printer has LAN mode enabled
    • Check if the access code is entered incorrectly