Skip to main content

Connecting to a Network via SSH

  • Ensure the system is powered on and connected to the upper computer via serial port SSH. It is recommended to use MobaXterm_Personal.
  • Ensure the upper computer has installed the M2WE or 2.4G WiFi Module. For Lite2 and MiniPad, no module installation is required.
  • 2.4G WiFi Module, Lite2, and MiniPad can only use 2.4G WiFi and cannot use 5G WiFi.
  • Do not use dual-band merging for the network, otherwise, normal connection may not be possible.
  • Make sure the antenna is installed.
  1. In the SSH software, enter the nmtui command and press Enter. The interface shown in the image below will appear.
Loading...
  1. Press Enter, then select Activate a connection and press Enter again.
Loading...
  1. Select the network you want to connect to, press Enter, enter the WiFi password, then select OK to save the connection.
Loading...
  1. After connecting to the WiFi, press Esc a few times to exit the current interface, then enter ip a and press Enter.

The location shown in the image is the IP address of the upper computer.

Loading...
Loading...